Unsure of your ring size? Our ring sizer is a great way help you figure out your ring size. And best of all, we'll refund the cost with any ring purchase.
 
The ring sizer is like a belt for your fingers and like a belt, you want it to be firm but not uncomfortable. So, when you receive the ring sizer, follow these simple instructions:
 
1. Loop the ring sizer by putting the end through the “buckle”. Slowly pull it through until you have a size that you can easily put onto the finger
 
2. It sounds silly but make sure you use the actual finger you want to wear it. The fingers on our dominant hand are often larger than on the non-dominant hand. Ideally, measure 3 to 4 times at different times of the day - your fingers can be a different size in the morning than later in the day and are thinner when our hands are cold.
 
3. Put the ring sizer over the chosen finger and gently pull it tighter until you have the correct size. The measured ring size to use is the one on the inside of the buckle of the ring sizer
The correct size should allow the ring sizer to move over the knuckle with a little resistance when taking it off. If it requires quite a bit of force, or gets stuck, then the size is too small. 
 
4. If the gauge on the ring sizer shows a point between two sizes, use the larger one. It is better that a ring is a fraction too big, than too small
 
Ring sizing is about personal preference and not a perfect science, so even after following our helpful hints, sometimes the ring still doesn’t fit perfectly. Don't stress! We are happy to exchange your ring for a different size if needed